Gabon Gyratory Crusher,Gyratory Crusher Animation,Gyratory Crusher Parts

Gyratory Crusher Working Principle

The main shaft (B) of the crusher is radially guided in the rolling contact bushing in the upper main shaft bearing (A) and in the inner eccentric bushing in the lower eccentric bearing (G). The thrust bearing assembly (J) arranged on the piston of the hydraulic cylinder (K) ensures the axial support of the main shaft.

The rotation of the drive motor is transmitted via the transmission gear (H) to the eccentric bushing in the eccentric bearing (G). This rotating eccentric bushing is responsible for generating the wobbling motion of the main shaft (B) – this wobbling motion is characteristic of cone crusher.

Consequently, the crushing gap change continuously between the stationary concaves in the gyratory crusher housing and the wobbling crushing cone.

The feed material that enters the crushing chamber from the top is continuously crushed between the crushing tools (C) as it falls by gravitation until it exits the crushing chamber at the bottom (F).

The crushing gap is adjusted by hydraulically lifting or lowering the main shaft.
It also serves as overload protection when uncrushable foreign matter finds its way into the crushing chamber. Easy restart under load in an emergency due to hydraulic main shaft lifting and lowering.
Main shaft "jumping" under adverse crushing conditions is avoided by a pressurized hydraulic system ensuring permanent contact of the individual thrust bearing discs.
This hydraulic main shaft adjustment is particularly used with abrasive feed material and frequent corrections of gap setting.
The use of a bevel gear set with cyclopalloid toothing allows the installation of drive motors with higher ratings, if required.

Gyratory Crusher Design Characteristics

•Bevel gear with cyclo-palloid toothing
•Robust construction
•Drive motors with higher ratings upon request
•No idle strokes due to continuous crushing
•Possibility of direct feed
•High throughput rates
•Low fines content in the crushed material (if required)
•Optimum crushing ratio
•Different drive systems available
•Change of stroke through adjustment of eccentricity
•Start under load possible (in an emergency)
•Low power requirement
•Low operating and maintenance costs.
•Hydraulic main shaft adjustment and overload protection
 

Gyratory Crusher Design

A. upper main shaft bearing assembly with two-armed spider ensures a spacious feed opening, automatic grease lubrication with electronic and visual level control
B. main shaft
C. crushing tools made of highly wear-resistant material
D. cast-steel shell sections, weight-optimized by means of FEA calculations
E. low-maintenance dust seal, highly efficient due to compressed air
F. large discharge openings owing to three-armed bottom shell
G. eccentric bearing assembly with replaceable inner eccentric bushing for stroke adjustment, integrated counterweight to minimize unbalances
H. transmission gear including a device for setting the tooth clearance, safe lubrication due to hermetically sealed stationary lubrication, electronic and visual oil level and temperature control optionally: vibration control
I. bevel gear and -pinion with cyclo-palloid toothing ensures smooth running
J. lower thrust bearing of the main shaft
K. hydraulic cylinder for convenient main shaft adjustment under load and overload protection in case of uncrushable foreign matter being fed to the crusher

Gyratory Crusher Fields of Application

•Natural stone industry
•Lime and cement works
•Coal preparation plant

•Ore mines